Complete solutions for all pump requirements

Vacuum & Air

Pressure Pumps

Angular Contact Bearings - Are they being installed properly in your pumps?

News

The use of single row angular contact bearings has increased considerably during recent years, but are they being installed properly in your pumps?

This bearing is designed to support a heavy thrust load in one direction only. It can also handle a moderate radial load. The contact angle is achieved by a high shoulder on the inner ring and another high shoulder, diametrally opposite, on the outer ring. This design is usually used as matched pairs of single row bearings, but it must be noted that these are matched in production so that an even distribution of the load can be achieved without the use of shims.

Three alternative arrangements of the double angular contact bearings are possible and the bearings must be properly arranged so that the load lines will handle the anticipated thrust loads.

The Tandem arrangement has the load lines in parallel and the pair can accommodate axial loads in one direction only. This is generally not a problem as it is easy to identify during installation with the high shoulders being on the same side in both bearings.

If however, the load from the pump can change from one direction to the other, both the other two arrangements can handle such a condition; the Face to Face and the Back to Back. Consequently, we have the frequent question, “Is there a right way to install them?”

Many bearing suppliers will tell you that it doesn’t matter, but that is not always the case.

It is worthwhile to recognize that the Back to Back arrangement provides a greater angular rigidity and is a much better arrangement for accepting tilting moments that may result from shaft misalignment difficulties, and are more prevalent in end suction pumps where the thrust bearing is located beside the shaft coupling.

Therefore, the Back to Back arrangement must always be used in end suction pumps.

Although it is not critical in double ended pumps, where the thrust bearing is at the other end of the shaft from the coupling, it is a good idea to instill a constancy of application with these bearings. So always install the double row angular contact bearings in the Back to Back arrangement.

 

Ross Mackay is an internationally renowned expert in pumping reliability based in Canada. He specializes in helping companies increase their pump asset reliability and reduce operating and maintenance costs through pump training programs. He is the author of “The Practical Pumping Handbook”, and  “The Mackay Self-Directed Pump Reliability Training System”. For more information and to register to possibly attend a Dynapumps and Ross Mackay pump school in 2013 please click here.

 

We are members of the following associations: